Every drone pilot learns the same lesson eventually. Propellers are a consumable, not a permanent part, and a single careless landing on a rough surface can chip a blade enough to make the whole drone shake in the air. The 28pcs propeller set for the DJI Tello exists so that lesson never costs you a flight. It packs twenty eight spare blades in seven colors, enough for seven complete replacements of the drone, and I have been swapping them in and out to see how they match the factory parts.
One note before the details. This article contains affiliate links, and if you buy through one of them the site earns a small commission at no extra cost to you. That never changes what I test or recommend.
Design and Build
The set contains twenty eight propellers, which breaks down into fourteen pairs for the four rotors of a Tello, with spares left over. Each blade is a direct copy of the factory Tello propeller, including the little colored ring that marks orientation and the flat push on hub that mounts to the motor shaft. The seven color options range through a full palette, so you can keep the stock look or give the drone a fresh one.
Twenty eight blades also means you can outfit several drones, which is useful for a family that shares a Tello or a small fleet for a class project. The math works out to four full sets of four, with twelve blades remaining as a running reserve, which is a generous margin for anyone who flies often.
The blades are molded from a flexible nylon that matches the feel of the originals, stiff enough to hold their shape in flight but tough enough to flex on a light impact instead of shattering. The hub design is the important part, because it must seat cleanly on the Tello motor shafts and pull off again without tools. In my testing, the fit matched the factory parts closely enough that I could not tell them apart once mounted.
There is a small wrench included for removing blades, which is handy when a prop is stuck after a hard landing, and the whole set arrives organized rather than loose in a bag.
Key Features
The headline feature is simply the quantity. Twenty eight blades means the average beginner has months of crash replacements before needing to reorder, which is the honest reality of learning to fly a Tello. The set is effectively the maintenance budget for a new pilot, and it costs a fraction of what repeated single blade purchases would add up to.
The color coding is a genuinely useful feature, not just decoration. Tello propellers have left and right handed rotation, and mixing them up makes the drone refuse to take off or fly erratically. The different colors across the set make it easy to keep the left and right sets sorted and to spot a damaged blade at a glance before a flight.
The direct replacement fit means no adapters, no cutting, and no modification. Each propeller pushes onto the motor shaft exactly where the original sat, which keeps the Tello balanced and flying true. That simplicity is the quiet reason this set works so well in practice, because the fastest way to make a beginner drone fly badly is to introduce a part that needs filing or finesse to mount.
Real-World Performance
I flew the Tello with these propellers for two weeks, and the first check was a simple one: does the drone fly the same as it did with the factory blades? It did. The drone lifted off, hovered, and responded to input exactly as before, with no added vibration and no drift that I could attribute to the props.
Flight time held steady across my battery tests, which is the most telling measurement for a replacement propeller. A cheap knockoff blade with the wrong pitch will eat into hover time or make the motors work harder. These held roughly the same flight time as the originals across multiple full battery cycles, which tells me the geometry is right.
That consistency matters more than it sounds. A propeller set that flies slightly off balance does not show up as a dramatic failure, it shows up as a constant, draining vibration that slowly wears the motors and ruins footage. I saw none of that here, and the drone tracked straight and held position exactly as it did on the factory blades.
The real test came when a blade chipped in a hard landing on concrete. I swapped in a spare in under a minute using the included wrench, and the drone flew normally on the next battery with no shakiness. That is the entire point of the set, and it delivered. I also deliberately mixed the color sets to confirm the left and right identification worked, and the marked rings prevented any confusion.
Pros and Cons
Pros:
- Twenty eight blades for months of replacements
- Seven color options with orientation marking
- Direct fit for the DJI Tello, no modification needed
- Included wrench makes swaps easy
- Flight time and handling match the factory props
- Budget friendly way to keep flying
Cons:
- Blades are consumable, wear is expected
- Color variety may not suit every taste
- Only fits the Tello, not other DJI models
How It Compares
The useful comparison for a spare parts buyer is between buying a bulk multi color set like this one and buying single factory blade pairs each time a prop breaks. The table shows how the economics and convenience stack up.
| Feature | 28pc Multi Color Set | Factory Single Pairs |
|---|---|---|
| Blades included | 28 | 2 per pack |
| Cost per blade | Much lower | Higher |
| Color variety | Seven colors | Stock colors |
| Replacement frequency | Rarely need to reorder | Repeated reorders |
| Fit quality | Matches factory | Factory exact |
For a beginner who will chip blades while learning, the bulk set is the smart buy, because the cost of repeated single packs adds up fast and the practical fit is identical. Pilots who fly rarely and keep the Tello in pristine condition may prefer the factory packs for absolute fidelity. For everyone else, the economics of twenty eight blades are hard to argue with. You can check the current price of the 28pcs DJI Tello propeller set on Amazon to compare.
Who Should Buy It
Buy this set if you are learning to fly a Tello and know you will scrape a few landings, if you fly regularly and want a stocked spares kit, or if you are buying a Tello as a first drone and want the maintenance supplies bundled in from day one. It is also a practical gift for anyone who owns a Tello, because spare props are the gift they will actually use.
Skip it if you already have a large stock of Tello blades or if you fly so rarely that a few spares will last years. For the typical Tello owner, a bulk blade set is the difference between a crash ending your afternoon and being back in the air in minutes. The 28pcs DJI Tello propeller set listing on Amazon has the full color breakdown.
How We Test
I tested the propeller set by using it as the only source of blades on a DJI Tello for two weeks. I measured flight time across full battery cycles, compared handling and vibration against the factory propellers, chipped a blade in a controlled hard landing, and swapped in spares to confirm the replacement process. I also verified the left and right orientation marking under different color combinations.
I did not instrument the motors of the drone or run automated hover tests, because the practical tests of flight time, stability, and swap ease are what a pilot actually cares about. For broader reading on drone upkeep and flying tips, The Verge covers consumer drone news and guidance that is worth a look alongside this review.
28pcs DJI Tello Propeller Set: Questions People Ask
Do these propellers fit the DJI Tello without modification?
Yes. The blades are a direct replacement for the factory Tello propellers, mounting onto the motor shafts with no cutting, adapters, or changes to the drone.
How hard is it to replace a broken propeller?
It takes about a minute. The included wrench pops the old blade off and the new one pushes onto the shaft, and the color rings keep the left and right sets sorted.
Why do the blades come in seven colors?
The color variety marks orientation so left and right handed blades are easy to tell apart, and it also gives you the option to change how the drone looks.
Do I need tools to swap the propellers?
No. The blades push on and pull off by hand, and the small wrench in the kit handles any prop that sticks after a hard landing.
As an Amazon Associate, I earn from qualifying purchases.
